May 23, 2012, 08:38:35 PM
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News
: Welcome to LongDriveTalk.com!
Home
Help
Calendar
Login
Register
Chat
LongDriveTalk.com
>
Discussions
>
General LongDrivers Forum
>
Removing Epoxy from a previously-enjoyed shaft
Pages: [
1
]
Go Down
« previous
next »
Print
Author
Topic: Removing Epoxy from a previously-enjoyed shaft (Read 876 times)
0 Members and 2 Guests are viewing this topic.
Roach
Administrator
Trade Count:
(
3
)
phpBB Frequent Poster
Offline
Posts: 284
Removing Epoxy from a previously-enjoyed shaft
«
on:
December 18, 2003, 08:35:43 PM »
Does anyone have advice on how i should remove built up epoxy from the inside the tip of a shaft that was pulled from head?
Mike
Logged
TheClubBuilder.com
Trade Count:
(
0
)
phpBB Frequent Poster
Offline
Posts: 445
Epoxy in shafts
«
Reply #1 on:
December 18, 2003, 11:48:59 PM »
Mike take a 1/8 inch drill bit and drill it very slow. There should not be more than 1/2 of epoxy in the tip. If you do not remove the epoxy when you glue the shaft in the new head it will want to push back out.
Kenny
Logged
Pages: [
1
]
Go Up
Print
« previous
next »
Jump to:
Please select a destination:
-----------------------------
Classifieds and Product Reviews
-----------------------------
=> Classifieds and Wanted to Buy Ads
-----------------------------
Discussions
-----------------------------
=> General LongDrivers Forum
=> Sponsors Product Feature Board
=> APG Developmental Long Drive Tour
=> Independent Event Forum
=> Canadian Long Drive Forum
=> European LD Forum
=> Off Topic
Loading...
